AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Stepper motor serial controller11/30/2022 ![]() ![]() Try a value of about 500, this should cause the motor to turn through about 360 degrees. The following sketch uses the Serial Monitor, so once the sketch is installed and running, open the Serial Monitor and enter a number of ‘steps’. The Stepper library is included in newer distributions of the Arduino IDE – you may need to upgrade. See the first image how the breadboard connection. Push jumper wires into the sockets to allow the motor to be connected to the breadboard. This means that there are a lot of connections to make on the breadboard. ![]() The stepper motor has five leads, and we will be using both halves of the L293D this time.
0 Comments
Read More
Leave a Reply. |